Skip to main content
Science Catalogs
Physical Sciences and Engineering

Niobium-tantalum sulfide alloy ink enables printed flexible supercapacitors

A team at Boise State University has produced the first aerosol-jet-printable ink made from a ternary transition metal dichalcogenide (TMD) alloy, (Nb₀.₅Ta₀.₅)S₂, according to the authors. Printed supercapacitors built with the ink stored far more charge than identical devices made from tantalum disulfide or niobium disulfide alone. The work, led by Fereshteh Rajabi Kouchi and David Estrada, appears in Communications Materials.

Why alloy two layered sulfides

TMDs are layered crystals in which a sheet of metal atoms sits between sulfur layers. Because the sheets are only a few atoms thick, nearly every atom is exposed to ions in an electrolyte, which suits supercapacitors. These devices store energy by gathering ions at an electrode surface and can charge and discharge much faster than batteries.

Niobium and tantalum are neighbours in the periodic table and both form layered disulfides. The researchers blended them in equal parts within a single crystal, treating composition as a tunable design variable, as in traditional metal alloys, rather than settling for the average of the two parents.

Designing an ink around the printer

With collaborators, the team grew the alloy as a bulk crystal and used ultrasound in a solvent to peel it into nanosheets, a method known as liquid-phase exfoliation. Of four solvents tested, one gave the smallest and most uniform sheets without oxidising them. However, it boils at about 284°C, which is too high for flexible plastic substrates.

The group therefore moved the nanosheets into a three-solvent blend, with each component doing a separate job:

  • ethanol keeps the ink thin enough to be turned into a mist;
  • 2-butanol slows evaporation so droplets do not dry before landing;
  • α-terpineol adds body and helps the dried film stay even.

According to the authors, the mixture also generates flows inside drying droplets that counter the coffee-ring effect, so the film dries flat. The ink needs no polymer binder and dries fully below 200°C.

Printed devices and performance

The researchers printed patterns on paper, sapphire and polyimide, with the finest features about 50 micrometres wide. To make supercapacitors, they printed interdigitated gold electrodes shaped like interlocking combs, then printed the alloy ink on top.

The best devices reached 11.05 millifarads per square centimetre and 184.2 farads per cubic centimetre, which the authors say exceeds earlier printed TMD supercapacitors. Power density was 883.8 microwatts per square centimetre.

The comparison with the parent materials is the central result. Identical devices made from tantalum disulfide stored roughly one-tenth as much charge as the alloy, and niobium disulfide performed barely at all. The combination therefore behaved differently from either component.

Limitations and next steps

Durability is the main weakness. The devices kept about 60% of their capacity after 2,200 charge-discharge cycles, and the authors name improving this as a priority. The source also reports no tests on integrated sensors or wearables, so practical performance in a complete system remains to be shown.

The team presents the work as a repeatable recipe: synthesise a new layered material, exfoliate it gently, tailor the ink to the printing method, then build and test the device. They note it follows their earlier work on printed MXene inks and suggest it could extend to other alloyed two-dimensional materials now being identified. If cycling stability improves, such inks could support small, flexible power sources printed directly on sensor patches, smart labels or wearable electronics.

The research involved collaborators at Penn State, the University of Illinois Chicago, Tulane University and Southern Methodist University.

Source: Better together: How two metals and one ink are reshaping printed energy storage (Tech Xplore, 20 November 2026).

Image: AI-generated illustration.

Working on this topic? Find a journal for your research or join the discussion on Scholars Post.